Précautions pour Fonctionnement Le Hydraulique Levage Système De Dump Semi Remorque
Laisser un message
(1) Le réservoir hydraulique du châssis benne basculante pour vente enchère est un spécial levage cylindre. Don't use the cylinder as a stable support for the dump trailer body.
(2) Ne pas quitter le cylindre exposé à l’air pour plus que 2 heures (plus de 30 minutes dans l’air humide) in a lifted état, sinon it will cause oxydation et rouille de le cylindre;
(3) It is forden to disassemble and adjust the relief valve on the lift valve, otherwise the hydraulic system will perd it safety protection function and cause an accident.
(4) Quand le Dump Semi Remorque pour vente charge cargaison, nous devrions s’assurer que le avant et arrière et gauche et droite chargement sont uniformes. Si vous avez trop beaucoup cargo in front, it can surcharge le système hydraulique. Trop beaucoup cargaison est chargé derrière le 20% 2640 pieds Conteneur benne basculante Semi remorque Semi Remorque Semi Remorque T T Fall
(5) When unloading, please make sure that the ground around the light weight tip trailer is solid and flat, keep the triple axle dump trailer stable, and ensure that the main dump truck and the Scrap Tipper Trailer are in a straight line;
(6) pendant le semi bascule pour vente levage opération, le opérateur ne peut pas quitter le fonctionnement position, et non un can stand or walk in the vicinity of the work area;
(7) pendant le dump semi remorque levage opération, the operator doit payer attention à la influence de latéral vent, parce que the long body of the dump semi-trailer will cause the dumper trailer to roll over under the effect of lateral wind;
(8) Don't make the height of the cargo exceed the back door. Be sure to open the rear door locking device before lifting and unloading, otherwise the cargo will be crowded at the re_retract of the tractor tipping trailer and the vehicle will tip over when unloading;
(9) Quand déchargement à températures ci-dessous 0 degrés, it is important à payer attention à si la cargaison gelé, sinon le arrière dump semi remorque volonté roll over due à déséquilibre entre gauche et droite quand déchargement;
(10) Do not move the dump semi trailer while the dump semi trailer is in the lifted state, and don't use the emergency braking method to unload sticky goods, otherwise it will cause the tractor tipping trailer to roll over or damage the oil tank;
(11) If the dump semi trailer lifting angle of the box reaches about 25 degrees, and the cargo in the box has not been unloaded, please stop lifting and check the cause of stickiness;
(12) If the anticipation that a rollover may occur during lifting, be sure to stop lifting and drop the tipper semi trailer slowly;
(13) Attendez pour environ 30 secondes après le schmitt dump semi remorque corps complètement inférieur. Make sure to keep the handle of the air control valve in the stop position. Do not start the heavy duty dump trailer in the lowered position. Do not drive the dump trailers in the lowered position. Autrement, all the dump semi trailer hydraulic oil in the hydraulic cylinder will flow back into the hydraulic tank, causing cavitation et Carburant injection problème.






